Reset SPS

After a certain amount of time SPS will generate an out-of-memory problem. This usually causes the actual RSE on SAMS to rise. To avoid this SPS should be reset..

1. First, locate the KVM Switch panel on the equipment rack. Press button #3. Immediately to

the left of the equipment rack, the Frijole monitor will display the SPS GUI.

2. If SAMS is open-looped, you may exit the SPS GUI by selecting Exit from the File menu.

Otherwise, you cannot exit SPS until the busy light on PMC is off.

3. Wait at least 5 seconds before starting the SPS software. Double click on the SPS v2.0.16

The GUI should appear instantaneously.