| | 45 | == System Initialization |
| | 46 | * On the TCS GUI under the legacy tab, home the dome and move the structure to CCAS. |
| | 47 | |
| | 48 | === SAMS (Segment Alignment Maintenance System) Initialization |
| | 49 | 1.) On the SAMS Server GUI, monitor Jove: 0.0 (desktop 1), click on "Set Reference" and then select "Restore Old Reference" on the popup. Click OK. |
| | 50 | |
| | 51 | 2.) In the FILE DIALOG pop up, select the appropriate reference file from the choices presented - usually "sam.ref", if not then most recent is usually best. Click OK. |
| | 52 | |
| | 53 | 3.) After the (greyed-out) slider turns back to black click the Standby-Operate Slider from Standby to Operate. |
| | 54 | |
| | 55 | 4.) The target RSE under the history tab needs to be below 500 to close the loop. |
| | 56 | [wiki:NightOperations/OPSManaul/Setup_Desktop/Problem_Solving_System PROBLEM SOLVING] |
| | 57 | |
| | 58 | 5.) To close the loop: On the SCS GUI click the radio button on the left under Move Authority labeled SAMS. The "POWER" LED under "System Status" should go red immediately and soon the red light will move to "Move Pending" and then to "Moving". |
| | 59 | |
| | 60 | 6.) In the SAMS Server window, check that the RSE has come down to within 150 of the TRSE. |
| | 61 | |
| | 62 | 7.) If so then, open the loop by changing the SCS Authority radio button on SCS to "none" and moving the Standby-Operate slider from Operate to Standby. |
| | 63 | '''Note''': If you have to leave the facility for some reason and the night TO is not there yet, do not leave SAMS in open loop form. Place it on standby with SCS moved to none. |
| | 64 | |
| | 65 | === Restarting PFIP and the compactRIO |
| | 66 | 1.) Go to the APC GUI and locate the power button for the compactRIO under the PFIP section. It should be listed PFIPContrlr. |
| | 67 | |
| | 68 | 2.) Power it off and wait 15 seconds before turning it back on again. |
| | 69 | |
| | 70 | 3.) Wait for all the buttons on the PFIP/FCU control/status tab to power off. Once everything has powered off, go ahead and power them on again. |
| | 71 | |
| | 72 | 4.) When everything has been powered on, restart the servers and the TCS GUI. |
