Changes between Version 8 and Version 9 of TOManual/stack1
- Timestamp:
- Jan 5, 2019 2:27:06 AM (5 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
TOManual/stack1
v8 v9 25 25 == '''Procedure''' == 26 26 27 1) Switch to Hefi view on video 6. In the HEFI GUI, move HEFI mirror IN and light source to high. A blurb of light on the overhead screen should appear; this is the array. If it doesn’t appear, the dome or the CCAS shutter is closed. It could also be that it is out of frame. The light can be moved around from the MARS GUI on the X and Y coordinate system. Once you have centered the HEFI spot move on to step 2.27 1) When the RA tells you that you can go stack, note the time as your “start stacking time” in the night report. 28 28 29 30 2) Note the time as your “start stacking time” in the night report. 29 2) Switch to Hefi view on video 6. In the HEFI GUI, move HEFI mirror IN and light source to high. A blurb of light on the overhead screen should appear; this is the array. If it doesn’t appear, the dome or the CCAS shutter is closed. It could also be that it is out of frame. The light can be moved around from the MARS GUI on the X and Y coordinate system. Once you have centered the HEFI spot move on to step 2. 31 30 32 31 3) Center the array (blurb) in HEFI view. Using the MARS GUI on the right-hand-side towards the middle of the page you can enter x and y values and move those directions via the Left, Right, Up, Down X-Y Step Motion buttons. Remember that in HEFI view the horizontal axis is fixed but the vertical is inverted. Therefore, if you want to move the image up you must command the y-value to go down. Steps in this view are normally several hundred. When HEFI is well centered move on the step 4.